1. The sensor will need to be powered on.
Insert 2 AAA batteries from your MySense box in the vibration sensor with the toilet icon. To insert the batteries, remove the cover strip:
To remove the cover strip:
Gently press down on the ridged thumb press located at the top of the sensor to remove the backplate.
Once pressed you can pull the backplate of the sensor away from the front cover allowing access to the batteries
With the batteries properly in place and the plastic cover strip removed the sensor can be clipped back together
2. Check if the sensor has power by pressing the circle on the front of the sensor firmly. The LED above the button should flash red once.
3. Place the sensor.
Sensor placement depends on the type of toilet and access to the flush mechanism.
If the toilet cistern can be accessed, lift the lid off the toilet and lay the sensor flat on top of the flush mechanism, above water height:
- If you cannot access the cistern, the sensor can be attached to the toilet lid or underside of the cistern.
- In some cases, the toilet cistern is concealed in a wall with only push buttons exposed. Here the sensor can be placed on or beside these buttons.
Watch our video below to see how to install the toilet sensor: